[111193.881815] usb 1-3.3: USB disconnect, device number 10
[111196.640195] usb 1-3.3: new high-speed USB device number 11 using ehci-pci
[111196.740061] usb 1-3.3: New USB device found, idVendor=058f, idProduct=6387
[111196.740067] usb 1-3.3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[111196.740071] usb 1-3.3: Product: Intenso Alu Line
[111196.740073] usb 1-3.3: Manufacturer: Alcor Tech
[111196.740075] usb 1-3.3: SerialNumber: 13091700015152
[111196.740637] usb-storage 1-3.3:1.0: USB Mass Storage device detected
[111196.741063] scsi11 : usb-storage 1-3.3:1.0
[111197.743101] scsi 11:0:0:0: Direct-Access     Intenso  Alu Line         8.07 PQ: 0 ANSI: 4
[111197.743923] sd 11:0:0:0: Attached scsi generic sg4 type 0
[111197.746005] sd 11:0:0:0: [sde] 30310400 512-byte logical blocks: (15.5 GB/14.4 GiB)
[111197.747829] sd 11:0:0:0: [sde] Write Protect is off
[111197.747844] sd 11:0:0:0: [sde] Mode Sense: 23 00 00 00
[111197.749095] sd 11:0:0:0: [sde] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[111197.759949]  sde: unknown partition table
[111197.764106] sd 11:0:0:0: [sde] Attached SCSI removable disk

<-- Schreibzugriff -->


[111364.662523] sd 11:0:0:0: [sde]  
[111364.662534] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
[111364.662541] sd 11:0:0:0: [sde]  
[111364.662545] Sense Key : Not Ready [current] 
[111364.662552] Info fld=0x0
[111364.662558] sd 11:0:0:0: [sde]  
[111364.662566] <<vendor>> ASC=0xff ASCQ=0xffASC=0xff <<vendor>> ASCQ=0xff
[111364.662573] sd 11:0:0:0: [sde] CDB: 
[111364.662577] Write(10): 2a 00 00 00 00 00 00 00 08 00
[111364.662592] end_request: I/O error, dev sde, sector 0
[111364.662598] Buffer I/O error on device sde, logical block 0
[111364.662602] lost page write due to I/O error on sde
[111364.679250] sd 11:0:0:0: [sde] Write Protect is on
[111364.679257] sd 11:0:0:0: [sde] Mode Sense: 23 00 80 00
[111364.686224]  sde: unknown partition table